VR Sm2 (Original Livery)

When will I stop making Finnish trains? Will I ever? Probably, either when I draw them all, or when I die!

This is an Sm2, in original VR livery, what do you guys think

It does not have bogies yet and the floor, roof and curvature of the body is quite complicated. If you are going to attempt to build this, you will have to cut your own tabs out of the train, and good luck folding it...

I would suggest waiting until I make it before trying, this will be very hard to do!

Bogies will come with the next version

The one on the left is an Sm2-class motor car, the one on the right is an EiOC-class trailer car.

They are attached below, and will likely take about 30min-1hr each to build

I drew these completely by myself, with no references, only measurements. Even with that said, the front end was an approximation. I drew these because Clem wanted them. He requested No. 6098, here it is!

The pieces match the curvature of the roof, and the pantograph was stolen from one of Clem's models (but I think that, by now, this pantograph is standard).

If you want bogies, use MI2N bogies for now, print them to size of the train. I will make bogies for this train someday!

Anyways, enjoy my most technical build (if you do not die trying to finish it)

I will publish photos of it, when built. This will likely be in one-two months.

Sm2 (Motor car)

EiOC (Trailer Car)
 

Distributed under a CC-ShareAlike-4.0 License